Add terminology support

neofetch

@@ -2277,23 +2277,41 @@ getimage () {
     stty -echo
     if [ -n "$TMUX" ]; then
         printf "%b%s" "\033Ptmux;\033\033[14t\033\033[c\033\\"
+
+    elif [ "$image_backend" == "tycat" ]; then
+        printf "%b%s" "\033}qs\000"
+
     else
         printf "%b%s" "\033[14t\033[c"
     fi
 
     # The escape code above prints the output AFTER the prompt so this
-    # loop below reads it as input. wtf xterm
+    # loop below reads it as input. wtf xterm / terminology
+    if [ "$image_backend" == "tycat" ]; then
+        read -t 1 -s -r term_size
+    else
         read -t 1 -d c -s -r term_size
+    fi
     stty echo
 
     # Split the string
+    if [ "$image_backend" == "tycat" ]; then
+        lines=${term_size%%';'*}
+        columns=${term_size%';'*';'*}
+        columns=${columns#*';'}
+        font_height=${term_size##*';'}
+        font_weight=${term_size#*';'*';'}
+        font_weight=${font_weight%';'*}
+        term_height=$((font_height * columns))
+        term_width=$((font_weight * lines))
+    else
         term_size=${term_size//'['}
         term_size=${term_size/';'}
         term_size=${term_size/$'\E4'}
         term_size=${term_size/t*}
         term_height=${term_size/';'*}
         term_width=${term_size/*';'}
-
+    fi
 
     # If $img isn't a file or the terminal doesn't support xterm escape sequences,
     # fallback to ascii mode.
@@ -3287,6 +3305,10 @@ if [ "$image" != "off" ]; then
     # If iterm2 is detected use iterm2 backend.
     if [ -n "$ITERM_PROFILE" ]; then
         image_backend="iterm2"
+
+    elif [ ! -z "$(tycat 2>/dev/null)" ]; then
+        image_backend="tycat"
+
     else
         image_backend="w3m"
     fi
@@ -3311,6 +3333,10 @@ if [ "$image" != "off" ] && [ "$image" != "ascii" ]; then
         "iterm2")
             printf "%b%s\a\n" "\033]1337;File=width=${width}px;height=${height}px;inline=1:$(base64 < "$img")"
         ;;
+
+        "tycat")
+            tycat "$img"
+        ;;
     esac
 fi